FOBSUN ELECTRONICS LIMITED
6F, BLDG. B, BINHAI TOWER, SOUTH OF XINHUA RD, BAO¡¯AN CENTRAL DISTRICT, 518101, SHENZHEN, CHINA
Tel: +8675533662112
During normal hours the Health, Safety and Environmental Department.
Normal hours call Tel: +8675533662112
/ |
LED |
54% |
/ |
PCB |
10% |
/ |
RESISTANCE |
5% |
/ |
PLASTIC |
18% |
/ |
ALUMINUM ALLOY |
10% |
/ |
COPPER |
2% |
/ |
WIRE |
1% |
Supply fresh air. If required, provide artificial respiration. Keep patient warm.
Seek immediate medical advice.
Immediately wash with water and soap and rinse thoroughly.
Seek immediate medical advice.
Rinse opened eye for several minutes under running water. Then consult a doctor.
After swallowing Seek immediate medical advice.
THERE ARE NO KNOWN HEALTH HAZARDS FROM EXPOSURE TO LAMPS THAT ARE INTACT.
Product is not flammable. Use fire fighting measures that suit the surrounding fire.
Wear self-contained respirator.
Wear fully protective impervious suit.
Wear protective equipment. Keep unprotected persons away.
Ensure adequate ventilation
Do not allow materials to be released to the environment without proper governmental permits.
Use neutralizing agent.
Dispose contaminated material as waste according to item 13.
Ensure adequate ventilation.
See Section 7 for information on safe handling
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
Keep container tightly sealed.
Store in cool, dry place in tightly closed containers.
Ensure good ventilation at the workplace.
No special requirements.
Keep container tightly sealed.
Store in cool, dry conditions in well sealed containers.
Properly operating chemical fume hood designed for hazardous chemicals and having an average face velocity of at least 100 feet per minute.
Not required.
The usual precautionary measures for handling chemicals should be followed.
Keep away from foodstuffs, beverages and feed.
Remove all soiled and contaminated clothing immediately.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Use suitable respirator when high concentrations are present.
Safety glasses
Tightly sealed goggles
Full face protection
Form: Solid
Color: Black, white
Odor: Odorless
Melting point/Melting range: Not determined
Boiling point/Boiling range: Not determined
Sublimation temperature/start: Not determined
Flash point: Not applicable
Ignition temperature: Not determined
Decomposition temperature: Not determined
Danger of explosion: Product does not present an explosion hazard.
Decomposition will not occur if used and stored according to specifications.
Acids
Oxidizing agents
Dangerous reactions No dangerous reactions known
Dangerous products of decomposition: None known.
Corrosive effect on skin and mucous membranes.
Irritant to skin and mucous membranes.
Strong corrosive effect.
Irritating effect.
Sensitization: No sensitizing effects known.
Cerium salts increase the blood coagulation rate. Exposure to cerium salts may increase sensitivity to heat, itching and skin lesions. Large doses to experimental animals have caused writhing, ataxia, labored respiration, sedation, hypotension and death by cardiovascular collapse.
Corrosive materials are acutely destructive to the respiratory tract, eyes, skin and digestive tract. Eye contact may result in permanent damage and complete vision loss. Inhalation may result in respiratory effects such as inflammation, edema, and chemical pneumonitis. May cause coughing, wheezing, laryngitis, shortness of breath, headache, nausea and vomiting. Ingestion may cause damage to the mouth, throat and esophagus. May cause skin burns or irritation depending on the severity of the exposure.
Swallowing will lead to a strong corrosive effect on mouth and throat and to the danger of perforation of esophagus and stomach.
To the best of our knowledge the acute and chronic toxicity of this substance is not fully known. No classification data on carcinogenic properties of this material is available from the EPA, IARC, NTP, OSHA or ACGIH.
Do not allow material to be released to the environment without proper governmental permits.
Recommendation
Consult state, local or national regulations to ensure proper disposal.
Recommendation: Disposal must be made according to official regulations.
Not a hazardous material for transportation.
Hazard class: None
Land transport ADR/RID (cross-border)
ADR/RID class: None
IMDG class: None
ICAO/IATA Class: None
Not dangerous according to the above specifications.
Observe related general safety regulations when handling chemicals
All components of this product are listed in the U.S. Environmental Protection Agency Toxic Substance Control Act Chemical substance Inventory.
For use only by technically qualified individuals.
This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
This information in this MSDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS damages resulting from use or reliance upon this information.